• Email More Options Modal Window

  • Remanufacturing the Xerox Versalink B400/405 Toner Cartridge

    Xerox Versalink B400/405 Toner
    Xerox Versalink B400/405 Toner

    By Mike Josiah and the Technical Staff at Uninet

    The Xerox Versalink B400/405 is based on a 47ppm 1200 x 1200 DPI monochrome engine. The toner cartridge is a long round tube type cartridge that houses the toner and reset chip. The printer is rated for up to 150,000 pages/month and comes with a STD 2GB memory.

    This cartridge is another in the “Easy to Do” series where the profit is high and the time to remanufacture is minimal.

    There are three different yield cartridges available for this series.

    The part numbers and list pricing for these toners are as follows:

    STD Yield 106R03580 5,900 pages $169.99*
    High Yield 106R03582 13,900 pages $283.99*
    Extra High Yield 106R03584 26,400 pages $379.99*

    There is also a drum cartridge used in this engine which will be covered at a later date

    Drum Cartridge 101R00554 65,000 pages $87.99*

    * Pricing as of September 1st 2019

    Current machines released so far are:


    Required Tools

    Toner approved vacuum.

    Small jewelers type common screwdriver

    Required Supplies

    Toner for use in the Xerox Versalink B400/405 toner cartridge: Choose the correct gram weight for your cartridge

    Replacement reset chip: Choose correct yield
    NOTE: There is a large end cap on the left (NON Gear side) of the cartridge, but the plastic is so rigid and tabs so tight it’s very difficult to remove. I highly recommend using the toner port instead. See Figure 1

    Figure 1
    Figure 1

    1) Vacuum the exterior of the cartridge

    2) Remove the Toner Port cover by pressing in on the small tab and sliding the cover open. Remove the cover. See Figures 2 & 3

    Figure 2
    Figure 2

    Figure 3
    Figure 3

    3) Dump the remaining toner.

    4) Vacuum/blow out the cartridge until clean. Use only low pressure air! (High pressure air can cause leaks in the seals).

    5) Fill the cartridge through the toner port with the appropriate amount of toner for use in the Xerox Versalink B400/405. Make sure you’re using the correct amount of toner to match your replacement chip. See Figure 4

    Figure 4
    Figure 4

    6) Replace the toner port cover and slide to close. See Figure 5

    Figure 5
    Figure 5

    7) Replace the chip by releasing the two tabs on the chip holder, slide the holder over to remove. Remove the old chip by pressing in on the two tabs and replace with a new one. Make sure the new chip aligns with the end supports. Slide the chip and holder back into place. See Figures 6, 7, 8 & 9

    Figure 6
    Figure 6

    Figure 7
    Figure 7

    Figure 8
    Figure 8

    Figure 9
    Figure 9

    8) Wipe the cartridge down to remove any remaining toner dust. Check for leaks on the toner port. If there are, the slide cover probably isn’t fully locked

    That’s it! You’re done! Simple, fast and profitable!https://static.ombe.com/slir/w125/forums/200/rickpics/Uninet_Imaging_Logo.jpeg
  • Locator Magazine Online

    Locator Magazine
  • trn_rightbar_1

  • Social Icons & OMBE Hot 100

    Click below to see OMBE.com's Top 100 Most Popular Products.

  • Visit Closeout Corner

  • Visit As Is

  • Homepage Right Skyscraper

  • On the Forums Title

    On The Forums
  • On The Forums


    Laser printer toner refill

    In my opinion, it's better to buy a new toner because you can be sure that everything is going to work. I tried refilling toners so many times and I can

    Dsuar2 11-18-2020, 04:45 PM Go to last post


    Hey guys, I suppose I didn't find a proper place for introducing myself but I have just registered here so I don't know anything, I hope I will enjoy

    Dsuar2 11-18-2020, 04:43 PM Go to last post

    Pitney Bowes Ribbon Cartridges

    Munich Motor Works provides one of the best Independent German and European car services in the UAE. Professional and experienced staff ensure ‘right

    ahsan_azs 10-19-2020, 09:51 AM Go to last post

    Ui design services

    Ui design services
    Origami Studios is a team of highly proficient app developers, passionate UX/UI designers, focused solution architects and creative

    ahsan_azs 09-26-2020, 12:00 AM Go to last post

    Hire ux designer

    Origami Studios is a team of highly proficient app developers, passionate UX/UI designers, focused solution architects and creative digital product developers

    ahsan_azs 09-23-2020, 11:02 PM Go to last post

    Azs marketing

    Web analytics is the measurement, collection, analysis and reporting of web data for purposes of under standing and optimizing web usage.

    ahsan_azs 09-02-2020, 04:35 AM Go to last post

    Peak Business Equipment, Inc. - Operating Hours

    Forum PostFrom Peak Business Equipment, Inc.

    "I hope you and your staff are doing well.

    I am sending everyone a quick email

    Webmaster 03-26-2020, 09:27 AM Go to last post

    Rainbow line on all printed page

    Yes you are right. I also faced the same problem but found a solution.

    SpencerBullock 09-04-2019, 07:41 AM Go to last post

    Rainbow line on all printed page

    In my opinion, the problem might be with the cartridge. Please remove the cartridge and then again install it. If it does not work then I will suggest

    JamesEwing 07-22-2019, 12:21 PM Go to last post
  • Newsletter Signup, iContact, 2019